User manual

RM-2440 User Manual P/N 821574 Rev-C

Please refer to Figure-2a on the following page to familiarize yourself with the front panel features of the RM-2440 unit. The

following sections describe these features and are referenced, by number, to Figure-2a.

Section 2: Operation

Front Panel Features

LCD Video Display (1-4)

View input video sources here. Select one of two source inputs for each display by setting the A/B Source Select Switch

(Item 4) to the desired input. Screen image parameters are adjustable by four manual controls (Item 2).

LCD Video Display Controls (1-4)

Each LCD video display can be adjusted separately using these four image controls:

• BRT - Brightness; adjust for desired screen brightness.

• CNT - Contrast; adjust for desired image scene, dark-to-bright contrast.

• COL - Color Saturation; adjust for desired amount of image color saturation.

• TNT - Tint (Hue); adjust for desired image color hue (NTSC only).

Tally Indication LED (1-4)

This tri-color LED can glow RED, GREEN, or YELLOW to indicate tally status associated with the signal displayed. Refer

to pages 14 and 15 for tally connection details.

An optional audio indication module (AIM-1) may be installed into the Tally Control Connector on the rear panel (Item

E, page 10), which allows these LEDs to act as audio indicator lights. Please contact PANORAMAdtv for more information

about this optional feature.

A/B Source Select Switch (1-4)

In a standard configuration, this switch selects between the primary CVBS (A) and secondary CVBS (B) video source

inputs for the associated I/O Section.

If an optional input module (RMSDI-1 or RMSDI-2) is installed in an I/O Section, the associated switch selects between

the primary CVBS Input (A) source and the installed optional input video source (B).