User guide

© 2010 Wohler Technologies, Inc. All rights reserved.
11
RM-2435-HD User Guide
Using the OSD Menu
Using the OSD Menu
A description of how to use the OSD Menu follows. Also refer to Table
1–2 below for typical values and domain ranges.
1. Press the Menu button to display the menu.
2. Use the Up and Down buttons to navigate through the seven sub-
menu icons. The sub-menus are:
A. STATUS (No configurable options)
A. VIDEO
B. AUDIO
C. MARKER
D. OSD
E. USER CONTROL
F. USER CONFIG
3. Press the Enter button to enter the chosen sub-menu.
4. Use the Up or Down buttons to cycle through the sub-menu
selections.
5. When the desired option is highlighted, press the Enter button to
select it.
6. Use the
Up or Down buttons to adjust the parameter value up or
down, make a selection, or turn a function on or off.
Press the Menu button to back out of a parameter or sub-menu. Press
the
Menu button again to remove the menu from the screen.
Note:
If you do not press another button for approximately 10
seconds, the menu will disappear from the screen.