User guide

8 21 068: M P E G-3 27 0 & 4290 Use r Guide
© 20 13 Wo h ler Tec hn ol ogi e s, In c . A l l r ig h ts re se rved.
45
Ch apt er 4 Configuration
N et w or k Men u
configuration in each of the other screens. This option allows you
to copy all 6 presets from one screen to another.
6. Preset ID: The currently-recalled preset name and number are
shown. To name or rename a preset, recall it using the Load
Preset from function on this menu. Then click the Preset ID
function. An on-screen keypad is provided to use to enter text to
name each preset. Enter the text, by rotating the Volume knob to
highlight each character and the pressing it to add that character to
the text. Clear, Restore, Shift, Space, Backspace, and Done
controls are also provided. Up to 14 characters may be entered.
When you are finished, select Done. To save the new text, rotate
the Volume knob to highlight Save Preset ID and press it. To
quit without saving the name, press the Menu button instead.
Network Menu
Before the Ethernet port can be used, it must be configured. The
Network Menu where this is done is shown in Figure 4–12
Figure 4–12 Network Menu
Rotate the Volume knob to highlight the item to be adjusted, and then
press to enter it. Again rotate the Volume knob to the item you need to
change and press to replace it. A number in the keypad below will then
be highlighted. Rotate and press to select the new numeric entry. Use
IP Mask
Network Menu
1234 SavePort Number
0 1 2 3 4 5 6 7 8 9
Clear Done
IP Address 192 1168 25 Save
255 255255 0 Save
Gateway Address 192 1168 16 Save