User guide

8 21 068: M P E G-3 27 0 & 4290 Use r Guide
© 20 13 Wo h ler Tec hn ol ogi e s, In c . A l l r ig h ts re se rved.
39
Ch apt er 4 Configuration
GP I- In Men u
6. Center: The Center Marker enable is described in the Marker
Menu on page 35. The F1 through F6 buttons may control
whether the center marker shows on the screen or not. By default,
function button F1 controls this.
7. Area: The Area Marker enable is described in the Marker Menu
on page 35. The F1 through F6 buttons may control whether the
area marker shows on the screen or not. By default, function
button F1 controls this.
8. Safety: The Safety Marker enable is described in the Marker
Menu on page 35. The F1 through F6 buttons may control
whether the safety marker shows on the screen or not. By default,
function button F1 controls this.
GPI-In Menu
This menu programs the action of the GPI (General Purpose Interface)
inputs. The pin numbers of each input (as well as the other pins on the
GPI connector) are shown on this menu. Each input can control
multiple functions, if desired. By default, the GPI inputs are not set to
control any function. The GPI-In Menu is shown in Figure 4–8.
Figure 4–8 GPI-In Menu
GPI-In Menu
Blue Screen
Mono Mode
Video Scale
Level Meters
Center Marker
Gamma Set
Area Marker
Safety Marker
43 5
43 5
43 5
43 5
43 5
43 5
43 5
43 5