User guide

8 21 068: MP E G-3 2 70 & 4 290 Use r Guide

Ch apt e r 2 Qu ick St a rt

Sett in g up In pu ts

7. After a few seconds, the video should appear with the MPEG

Screen superimposed over it. If you prefer, you may remove the

superimposed MPEG Screen by pressing the Menu button twice.

Monitoring an Ethernet Stream

1. Connect the Ethernet plug to the ETHERNET jack on the back

panel of the MPEG-3270 or MPEG-4290. The one jack will serve all

four screens.

2. Press the Menu button to get to the Main Menu. Rotate the

Volume knob to highlight the Network Menu selection. Press

the Volume knob once to enter the Network Menu.

3. Rotate the Volume knob to each IP setting you need to change.

Press and turn the knob to make the changes. Press the Volume

knob to exit this menu into the Main Menu and then press it again

to exit the Main Menu.

4. Follow step 5 on page 17 through step 7 in the Monitoring an ASI

Stream section.

5. Press the Menu button twice to exit both the MPEG Screen and

the Main Menu. Press the Ethernet button. ETHUC: will appear

in the upper left corner of the screen. After a few seconds, the

video should appear. If you prefer, you may superimpose the

N ote:

This input does not support encrypted sources.

Video Menu

Main Menu

Audio Menu

Marker Menu

Functions Menu

OSD Menu

System Menu

Preset Menu

System Status

GPI-In Menu

Network Menu

MPEG Status

UMD Options Menu

IP Mask

Network Menu

1234 SavePort Number

0 1 2 3 4 5 6 7 8 9

Clear Done

IP Address 192 1168 25 Save

255 255255 0 Save

Gateway Address 192 1168 16 Save