User guide

8 21 068: M P E G-3 27 0 & 4290 Use r Guide
© 20 13 Wo h ler Tec hn ol ogi e s, In c . A l l r ig h ts re se rved.
17
Ch apt er 2 Quick Start
Sett in g up In pu ts
3. If it is not connected already, connect the ASI source to SDI/ASI
A IN. Press the SDI/ASI button repeatedly to light the A LED.
ASI A: will be indicated in the upper left corner of the screen:
4. When you see ASI-A:TSSync in the upper left corner of the
screen, the signal has been recognized.
5. Press the Menu button to open the Main Menu. Rotate the
Volume knob to highlight the MPEG Screen selection and press
it to enter the MPEG Screen. In the MPEG Screen, turn the
Volume knob to highlight the PID to view and then press to
select.
6. This will proceed to the next menu where you can select the video
and audio PIDs. Turn the Volume knob to the video and audio
PIDs of interest and press to select them. When selected, they are
bright green. When you have selected the audio and video PIDs,
turn the Volume knob to highlight SEL and Exit at the lower left
of the screen. Press the Volume knob to return to the MPEG
Screen.
Video Menu
Main Menu
Audio Menu
Marker Menu
Functions Menu
OSD Menu
System Menu
Preset Menu
System Status
GPI-In Menu
Network Menu
MPEG Status
UMD Options Menu
PAT 00 CAT 01 NIT 16 SDT 17 EIT 18 TDT 20 SIT 31
0
31
256
4113
4352
20
TS
Ports
SDI-A ASI-B Eth UC Sync ASI TS
PID Type SI PIDs
4113
4097
4352
Video H.264 1280 720 119.88 1:1 0x27 HDMV
PCR
Audio AAC Layer 0 0 44.1kHz Stereo Open/Cpy noRA
PMT PID 256 PGM # 1 HDMV No Curr SIT
EXIT Only Vid-PID 4113 Aud-PID ----SEL and Exit
4113
4097
4352
Video H.264 1280 720 119.88 1:1 0x27 HDMV
PCR
Audio AAC Layer 0 0 44.1kHz Stereo Open/Cpy noRA
PMT PID 256 PGM # 1 HDMV No Curr SIT
SEL and Exit EXIT Only Vid-PID 4113 Aud-PID ----