User guide

8 21 068: M P E G-3 27 0 & 4290 Use r Guide
© 20 13 Wo h ler Tec hn ol ogi e s, In c . A l l r ig h ts re se rved.
15
Ch apt er 2 Quick Start
Sett in g up In pu ts
4. After connecting the power cords, you should see the A and B
indicators below each screen light up. Press the Power button
located at the left under each screen.
5. For 30 seconds, the Power indicators should flash. Then the
screens should show a progress bar, followed by some white
flashes and a splash screen showing the MPEG Series product line.
The start up process takes just over a minute. When the start up
process is complete, you should see the words, “SDI-A: No Sync”
at the upper left of the screen, assuming that no SDI signal is in fact
present.
6. Proceed to Monitoring a 3G/HD-SDI Signal on page 15,
Monitoring an ASI Stream on page 16, Monitoring an Ethernet
Stream on page 18, or Monitoring an HDMI Signal on page 19,
depending upon your monitoring needs.
Setting up Inputs
Monitoring a 3G/HD-SDI Signal
1. Press the Menu button to open the Main Menu. Rotate the
Volume knob to highlight the System Menu selection and press
it to enter the System Menu.
2. The SDI option should already be selected by default on BNC
Ports A & B. If it is not set this way, it can be changed by pressing
the Volume knob once and then turning it to move the selector on
BNC Port A to SDI. Press the Volume knob once to select SDI.
Use the same process for BNC Port B if you intend to connect an
SDI signal to SDI/ASI Input B. Finally press the Menu button
twice to exit.
Video Menu
Main Menu
Audio Menu
Marker Menu
Functions Menu
OSD Menu
System Menu
Preset Menu
System Status
GPI-In Menu
Network Menu
MPEG Status
UMD Options Menu
BNC Port B
System Menu
Backlight Interval
Panel LEDs
Calibration
Upgrade
None 5m 4h 8h 24h 48h
Restore
Upgrade
SDI ASI
Off On
BNC Port A SDI ASI