Manual

Page 39
System Preferences
Click on System Preferences to find the Phase Indicator Configuration tab. This is
as shown in Figure 4-4. It allows you to select which channel pairs will receive a
phase meter on the Metering Screen. Generally, it is useful to monitor the relative
phase of stereo pairs. However, sometimes each channel of a pair is unrelated to
each other. This can be because the channels are used to convey two independent
monophonic signals or that one channel may be a Center channel and the other
may be a Low Frequency Effects channel. In these instances, the Phase Indicator
would almost always indicate an out of phase condition. Because this would be a
needless distraction to the operator, switches are provided on this tab to
individually turn phase monitoring for each channel pair on or off. Select All and
Reset All buttons are also provided.
Figure 4–4: Phase Indicator Configuration Tab
When you have finished making the settings click Apply to save them or click
Cancel to discard them.