Manual

Page 22
Unit Configuration
Touching the Unit Config selection on the Unit Settings Menu proceeds to the
Unit Config Menu. This menu is shown in Figure 2-16.
Figure 2-16: Unit Configuration Menu
Unit Config
Brightness
AES
Termination
Back
< >
80
Off
8 Channel
Mode
Off
Video Info
< >
Off
The controls function as follows:
1. Brightness: This setting adjusts the brightness of the display screen. Touch
the left pointing arrow to dim the brightness or touch the right pointing arrow
to increase the brightness.
2. Video Info: This setting determines if or how video information is displayed
when the video screen is selected by pressing the Source knob. The possible
selections are as follows:
a. Always On: The video information is always displayed.
b. Off: The video information is never displayed.
c. 5 Secs: The video information is displayed for 5 seconds after the
video screen is selected and then it disappears.
d. 10 Secs: The video information is displayed for 10 seconds after the
video screen is selected and then it disappears.
3. AES termination: AES signals should have one and only one termination.
This termination should physically be at the last destination of an AES coax
cable. If the iVAM1-1 is the last connection in a series of AES connections,
then its terminations should be turned on. A symptom of too many
terminations (or no termination) is that no signal appears to be present on
the AES input. Touch the On - Off switch to change the termination setting.
4. 8 Channel Mode: This setting selects whether 16 meters are shown on the
Metering Screen or whether 8 larger meters are displayed instead. If it is not
necessary to view 16 meters at a time, 8 larger, easier-to-touch meters can
be a better choice. Touch the On - Off switch to change the 8 Channel Mode
setting.
Touch Back to exit this menu.