Manual

Page 15
indicate what operation is being performed. Note that if it is not necessary
to view all 16 channels at the same time, 8-Channel Mode can be turned
on, resulting in 8 larger, easier-to-touch meters being displayed. The 8-
Channel Mode setting is in the Unit Config Menu. The following
describes each function:
a. Mute / Un-Mute Selection: A violet box surrounds any channel
pair that is muted. Typically, when the iVAM1-1 is first powered, all
of the channel pairs are muted. Touching a muted channel pair un-
mutes it and removes the violet box. Muting and un-muting by
touching is an alternate action function.
b. Solo Selector: Touch for two seconds any channel pair you would
like to solo. A blue box will then surround the pair and that will be
the only pair you hear. Any violet boxes will disappear. Touching
another channel pair will then move the blue box to it, and it will be
soloed. Touch again to return the combination of monitored channel
pairs to the way they were before you soloed the pair.
c. Channel Solo: Rotating the Channel control will move a white
selection box from channel to channel. Press the Channel control
to solo the selected channel. That channel alone will then be
surrounded by a blue box and it will the only channel being
monitored. Press the Channel control again or touch anywhere on
the meters to undo the solo and return the combination of
monitored channel pairs to as it was before you soloed the channel.
3. Phase Indicators: At the bottom of each channel pair is a Phase
Indicator. The indicators light a dull green if the channels in the pair are
in phase or bright red if they are out of phase. You may set which Phase
Indicators appear using the Phase Config Menu or with the System
Preferences: Phase Indicator Configuration tab in the Wohler Web
GUI.