Manual

Page 10
Rear Panel
The rear panel is shown in Figure 2-2.
Figure 2-2: iVAM1-1 Rear Panel Layout
Power Connection: The iVAM1-1 receives power from an AC inlet, which is a standard
IEC receptacle for 100 to 240 VAC ±10%, 50/60 Hz power connection. Four regional AC
power cords, supplied according to shipping region, are available.
1. SDI Inputs: These two BNC connectors accept the two 3G/HD/SD-SDI
input signals containing audio and video to be monitored. This is a
standard feature.
2. SDI Output: This BNC connector outputs the selected 3G/HD/SD-SDI or
SFP module input signal.
3. HDMI Output: An HDMI output of the monitored 3G/HD/SD-SDI or SFP
module video source is available from this connection.
4. Network Port: This Ethernet port can connect to either a LAN or to a PC
to let you perform administrative tasks remotely. The Wohler Web GUI is
described in Chapter 4 of this manual. Third party equipment, connecting to
the iVAM1-1 via a LAN plugged into this port and using an API commands, can
view and change product options, as well. This API is described in Appendix B
of this manual.
5. MADI BNC: (optional) The COAX input accepts an AES10 64-channel
signal at 48 kHz sample rate. An optional license key must be purchased to
enable this function. The COAX output is reclocked from the MADI source.
When power to the iVAM1-1 is not present, the COAX input and output
are automatically connected together to allow the MADI signal to pass
through. A software license must be installed for this input to function.
Refer to the System Setup section in Chapter 4 and to Figure 4-7 to
install software licenses.
6. MADI Fiber SFP: (optional) This input module accepts an optical AES10
64-channel MADI input signal at 48 kHz sample rate. An optional license
Important:
By design, the supplied AC mains power cord will only plug into a
three-prong grounded outlet for your safety. If the plug does not fit
into the outlet, contact an electrician to replace the obsolete outlet.