Manualshelf

User manual

ManualsBrandsWohler ManualsComputer equipmentAVMFlex-SA Series
12345678910
3
© 2005 PANORAMAdtv ALL rights reserved
AVMFlex-SA Series User Manual P/N 821624 Rev-A
General Features
and Specifications
Description
Features
Applications
AVMFlex-SA General Specifications
Model Configurations and Naming Convention
VPOD LCD Video Display Specifications
VPOD LCD Video
Section 1
Installation
Unpacking
Unpack the AVMFlex-SA Series unit from the shipping container and inspect all articles for shipping damage. If you find any damage,
notify the shipping carrier immediately for claims adjustments. Compare the shipping box contents to the packing slip. Contact a
PANORAMAdtv sales representative if there are any unexplained shortages.
Heat Dissipation
Heat dissipated by the speaker amps is conducted directly to the left side of the chassis; no special considerations for cooling are
necessary as long as the ambient temperature inside the rack area does not exceed approximately 40°C (104°F).
Sympathetic Vibration
Sympathetic vibration from other equipment (cables, etc.,) in the rack may be serious enough to interfere with the unit’s sound
quality out in the listening area. The use of thin card stock and/or felt or foam weather-stripping type materials between adjacent
vibrating surfaces, or tying up loose cables, etc., may be required to stop vibrations external to the unit.
Audio Connections
Connection of the audio feeds is straightforward. Please refer to the system interconnect block diagrams on page 26 for clarification of
the general signal paths into and out of the AVMFlex-SA Series units.
Rack Mounting
The AVMFlex-SA Series unit rack mounts in a standard EIA-310-D specification 19”/483mm rack and needs 1RU of space. Allow
sufficient space at the unit rear for connector and cable clearance (approximately 4”/102 mm). The AVMFlex-SA Series unit rack mounts
from the front panel support rails. Rear support is not required.
Cable Recommendation
Recommended cable type for analog video signals is: Belden 8281, Belden 1694A, or equivalent.
Recommended cable type for analog audio signals is: Belden 9451 or equivalent.