User guide

AVMFlex58W Series User Guide

Unpacking and Installation Recommendations

Unpacking and Installation

Recommendations

Unpacking

Unpack the AVMFlex58W Series unit from the shipping container and

inspect all articles for shipping damage. If you find any damage, notify

the shipping carrier immediately for claims adjustments. Compare the

shipping box contents to the packing slip. Contact a PANORAMA sales

representative if there are any unexplained shortages.

Mounting

The unit is designed to install into a standard 19" rack mounted at eye

level for best visual observation of the monitor screens. The

AVMFlex58W Series unit rack mounts in a standard EIA-310-D

specification 19”/483mm rack and needs 1RU of space. Allow sufficient

space at the unit rear for connector and cable clearance (approximately

4”/102 mm). The AVMFlex58W Series unit rack mounts from the front

panel support rails. Rear support is not required.

Heat Dissipation

The ambient temperature inside the mounting enclosure should not

exceed 40° Celsius (104° Fahrenheit). Adjacent devices can be rack

mounted (or stacked) in proximity to the unit if the above temperature

is not exceeded. Allow a 1RU (1.75”/44.45mm) space above and below

the unit for air circulation.

Power

The unit comes with a standard 24VDC/3.0A internal power supply

and connects an A/C mains power source (65W, 100 to 240 VAC, 50/

60Hz) to the IEC connector provided on the rear panel of the unit.

CAUTION!

In products featuring an audio amplifier and speakers, the surface at the side

of the unit, where the audio amplifier heat sink is internally attached, may get

very hot after extended operation. When operating the unit exercise caution

when touching this surface and ensure that external materials which may be

adversely affected by heat are not in contact with it.