User guide

AVMFlex58W Series User Guide

Rear Panel

SDI Output (BNC-F):The SDI output connector outputs a reclocked

(regenerated) copy of the of the signal entering the SDI input connector

and is configured for an unbalanced 75 Ω connection. This output

functions regardless of other selection settings so that the reclocked

output can remain independent of the unit’s other monitoring

functions (as long as a valid SDI source is present on the SDI input).

SDI/CVBS Out (BNC-F): CVBS video signal converted from SD-SDI

video. Active as long as SDI video is present.

CVBS In: Much like CVBS In B on LP2S model.

Tally Control

The VPOD LCD display module provides a dual-color tally indication

LED accessed by the tally control connector located on the chassis rear

panel. The tally indicator LED is capable of displaying three colors: red,

green, and amber. Illuminating the red or green LED separately will

result in that tally color. Illuminating the red and green LEDs

simultaneously creates the amber color. For tally control connector pin

out functions, see Table 1–5 on page 17 below.

Two examples of tally connection configurations are shown in Figure-

3b, below. You can operate the Tally Indication LED by numerous

methods. The two tutorial examples showing isolated and non-isolated

activation are illustrated to show basic operation. Although switches

are employed in these examples, the LEDs interface with TTL levels.

You can design illumination circuits as shown, by using TTL buffers, or

by using transistors as switches.

Isolated

Operating the Tally Indication LED in an isolated configuration

requires an external (customer provided) power supply and tally

system. If your facility currently has a tally system with companion

power source, use this method to integrate the AVMFlex58W Series

tally with your existing tally matrix.

Note:

Ensure the LED power supply provides +5 to +12VDC.