User guide

© 2009 Wohler Technologies, Inc. All rights reserved.
13
AVMFlex58W Series User Guide
Rear Panel
Balanced Audio Out: These two male 3-pin XLR connectors are analog
outputs of the source as selected for the left and right speakers. See the
diagram below for pin out information for these connectors.
Figure 1–3 XLR Pin Outs
Tally (DB-25): This 25-pin sub-miniature connector allows you to
control the tally light on the front of the VPOD. For more information
about this connector and how it functions, refer to Tally Control on
page 15.
AVMFlex58W-LP2S Rear Panel
Figure 1–4 AVMFlex58W-LP2S Rear Panel
Termination: Each switch in this two-section DIP module is used to set
the termination characteristics for the CVBS input connector next to it.
If a CVBS loop connector is connected to downstream equipment, set
the appropriate switch to the up position (Unterminate). If no
downstream equipment is connected, then set to the down position
(Terminate).
Female
Male
Power Connector
Tally
CVBS In and Loop Out A and B
Termination
Balanced Audio
A In
Balanced Audio
B In
Balanced Audio
Out