User guide

AVMFlex58W Series User Guide

Rear Panel

VPOD

Video signals entering the AVMFlex58W Series unit are monitored

through the VPOD LCD video display. The VPOD module is attached

to the front panel by a length of flexible gooseneck tubing allowing

angle viewing adjustment in all directions.

4:3/16:9 (Switch): Selects the image aspect ratio displayed. The

horizontal axis is narrow for 4:3 and full width for 16:9.

Input A/B (Switch): Pressing the switch up selects input A; pressing it

down selects input B.

PAL/NTSC (Switch): Pressing the switch up selects the PAL signal

type; pressing it down selects the NTSC input type.

Power (Switch and Indicator): Pressing the switch up powers the

video display monitor

TNT (Rotary Knob): Adjusts the video display hue (for NTSC only).

COL (Rotary Knob): Adjusts the video display color saturation.

BRT (Rotary Knob): Adjusts the video display brightness.

Tally (Indicator): This tri-color tally LED glows red, green, or amber,

to indicate tally status associated with the video signal displayed.

Rear Panel

The rear panel connector configuration for the AVMFlex58W-LP2S and

for the AVMFlex58W-SA are shown in Figures 1–4 on page 13 and 1–5

on page 14 respectively.

Common Connectors

Power Connector: Attach the supplied standard IEC-320 power cord

between this connector and mains power (100 - 250VAC, 50/60 Hz).

The front panel Power LED (Item 5, page 10) will glow green to indicate

operating voltages are present.