User manual

ATSC/DVB-3/M User Manual P/N 821650 Rev-B

Rear Panel Features

Selected Output (Analog) Connectors (Chan.A/Left and Chan.B/Right)

The two SELECTED OUTPUT (ANALOG) connectors (3-pin male XLR) are analog outputs of the input signals as

selected for active monitoring through the left and right speakers (or headphones). The left CH.A(L) connector outputs

the left speaker channel (channel A) and the right CH.B(R) connector outputs the right speaker channel (channel B).

Both connectors are configured for low impedance connections and the output signals are at unity gain with the input

level and are not affected by the units Volume and Balance controls or Headphone Mute feature. For XLR connector

pinout information, see the diagram under Item C, page 12.

OPT Mode Select Switch

This recessed 10-position rotary switch sets the mode of operation. When set to position 0, the unit is configured to download

programing information. When set to positions 1 through 9, the unit will operate normally. See below for setting information.

RS232 Connector

This DB-9 connector is used for downloading programming, setup, and diagnostic information into and out of the

919212 audio de-embedder.