User guide

821030: AMPx-S8 Series User Guide

Chapter 5 Setup Menu

Accessing Setup Mode

1. Enable Setup mode by pressing and holding the Fn button and

then pressing the Setup button. This mode is used to change unit

features.

2. You can step through the menu selections and parameters using

the

Up and Down buttons.

3. Press the

Enter button to save your selections. To cancel the

option and exit the menu, press the Escape button.

The current options in Setup Mode (as shown in Setup Menu Tree on

page 44) are:

• Preset Recall (RCallPSet)

• Preset Save (SavePSet)

• Preset Mode (PsetMode)

• Preset Erase (ErasePSet)

• SDI Delay (only available for the 3G model)

• Surround Gain (Srnd Gain)

• Startup

• Analog Output Preference (AOutPref)

After entering the Setup Menu, the display will indicate the software,

version number, and the menu selection: RCallPSet (if presets are

saved).

To select the current option, press the Enter button.

Table 5–1 Up Button List

Pressing the Up

Button the...

Changes the Display to...

1st time SavePSet

2nd time PSetMode (if presets are saved)

3rd time ErasePset (if presets are saved)

4th time SDI Delay (3G model only)

5th time Srnd Gain

6th time Startup

7th time A-OutPref

8th time RCallPSet