User guide

821030: AMPx-S8 Series User Guide

Chapter 3 Audio Configuration

Selecting the Input Signal

Figure 3–12 SDI Delay Setting

4. Press either the Up or Down buttons to select the delay in

milliseconds: Off or 0 to 170 (in 1 millisecond intervals).

5. Press the Enter button to make your selection and return to the

Setup Menu.

6. Press the

Escape button to return to normal operation.

Selecting the Input Signal

While the system is in normal operation, press the Input button to

cycle through each of the five selections. The selection is enabled when

it appears in the LCD screen. (Pressing the Enter button is not

necessary.)

• Analog

• AES

• AES1 (Unbalanced)

• AES2 (Balanced)

• SDI (not available in the DA model)

• Auto.SDI or Auto.SDI2 if no signal is present

• SD.SDI (signal is present and auto-detected)

• HD.SDI (signal is present and auto-detected)

• 3G.SDI (signal is present and auto-detected)

-Setup-

SDI Delay: 140 ms