User guide

821030: AMPx-S8 Series User Guide

Chapter 3 Audio Configuration

Analog Output Preference

The Analog Output Preference determines how the Selected/

Downmix Analog Output

connectors and the Metered Analog

Output

connector output the metered signals when either the DM1,

DM2, or DM3 downmix options are selected. Refer to Rear Panel

Connectors on page 13.

The default setting is Downmix, which outputs the speaker assign with

individual channel scaling (gain settings) intact as determined by the

selected downmix. However, if you select Discrete, then all channels

with the downmix are output from these connectors at unity gain

without scaling of the channels as determined by the selected downmix.

To change the analog output settings:

1. Hold the Fn button while pressing the Setup button.

2. Press the Down button until the LCD screens AOutPref as shown

in Figure 3–1 below.

Figure 3–1 Analog Output Preference LCD screen

3. Pressing the Enter button displays either Figure 3–2 or Figure 3–3

depending on the current setting.

Figure 3–2 Analog Output Preference Setting -

Discrete

Figure 3–3 Analog Output Preference Setting -

Downmix

848131 3.03

Setup: AOut Pref

-- Setup --

Aout Pref: Discr

-- Setup --

Aout Pref: D-mix