User guide

AMP2A-10S User Guide

Level Meter Settings and Specifications

Connector pinout information is silk-screened between the two

banks of input connectors.

• Selected Output Connectors (3-pin male XLR): These connectors

are analog outputs of the Analog Input Connectors (Item B or C) as

selected by the

Source Select Switch on the front panel. The left

connector outputs the left channel (Channel A) and the right

outputs the right channel (Channel B). Both connectors are

configured for low impedance connections and the output signals

are not affected by the volume/balance controls or headphone

mute. For XLR connector pinout information see the diagram in

Figure 1–3 on page 10.

Figure 1–3 Male XLR Pin-Out

Level Meter Settings and

Specifications

Level Meter DIP Switch Settings

Two DIP switch modules, accessed through holes in the top cover,

allow the user to set the VU/PPM display mode and input level gain

calibration. There are two DIP switch modules; one for each of the two

meter bar graphs. There are four sections (1, 2, 3, 4) on each DIP switch

module. The first two sections (1 and 2) are for setting the level meter

input level gain calibration and the second two sections (3 and 4) are for

setting the VU/PPM display mode.