User manual

AMP2-VS and AMP2-VSA User Manual P/N 821583 Rev-A

Level Meter Internal 10-Position DIP Switch Settings

PPPM Characteristics (Ballistics):

The PPM characteristics determine the Integration Time (rise time) and Return Time (fall time) of the level meter. The

Integration Time is the time it takes for the lighted segments of the level meter, after application of a 5 Khz tone at a certain

reference level, to rise within a specified number of dB of that level. Return Time is the time it takes for the lighted segments of

the level meter to fall a certain number of dB after removal of a 5 Khz tone of a certain reference level. The PPM characteristics

available for selection using DIP switch sections 7 and 8 of the 10-position Internal DIP Switch (as shown in the above diagram)

are as follows:

Integration (Rise) Time is 5 ms (-2 dB),

Return (Fall) Time is 1.7 seconds (20 dB)

Integration (Rise) Time is 10 ms (-2 dB),

Return (Fall) Time is 2.8 seconds (24 dB)

Integration (Rise) Time is 5 ms (-2 dB),

Return (Fall) Time is 1.5 seconds (20 dB)

Integration (Rise) Time is a single sample,

Return (Fall) Time is 1.5 seconds (20 dB)

IEC268-10, Type 1:

IEC268-10, Type 2:

DIN 4506:

Single Sample:

This 10-position DIP switch is accessed by removing the top cover of the AMP unit and is located on the 919174 PCB (the same

PCB on which the 6-position rear panel DIP switch is located). See page 21 for a diagram of the 919174 PCB and the DIP switch

locations.

Switch positions 1 and 10 are NOT used and should be left at the factory set position.

The Peak Hold - Manual setting allows the bargraph display meters to indefinitely maintain the peak hold value until it is reset by

the operator, either by pressing a reset button (a special option specified at time of order) or by removing power and then

reapplying power to the unit (unplug/replug power cord). Contact Wohler Technologies for more information about this feature.

Contact Wohler Technologies for information about custom scales.

NOTES:

Do Not Use

Section 3: Technical Information