User manual

AMP2-V2DA User Manual P/N 821539 Rev-A

Rear Panel Features

Section 2: Operation

High (+)

Low (-)

Gnd

(Shield)

Pin-1 Pin-2

Pin-3

Pin-1

Gnd

(Shield)

Pin-2

High (+)

Pin-3

Low (-)

Female XLR Pinout

Male XLR Pinout

(Continued)

Analog Input Connectors (1-4)

These four analog input connectors accept standard analog audio signals. These four 3-pin male Phoenix connectors are

configured for a balanced 200k Ω connection. Phoenix connector pin-out information is silk-screened just below the

CONVERTED ANALOG OUT connectors (Item G). Note that the unit will monitor the Analog inputs only when the Analog/

Digital Source Select Switch (Item 7, page 10) is set to "ANALOG".

Converted Analog Out Connectors (1-4)

These four Phoenix connectors output analog signals converted from the four AES/EBU digital inputs (but not the analog

inputs) and are not affected by the position of the Analog/Digital Source Select Switch (Item 7, page 10). These 3-pin male

Phoenix connectors are configured for a balanced low impedance connection. Phoenix connector pin-out information is

silk-screened just below these connectors.

Selected Analog Output Connectors

These two 3-pin male XLR connectors are analog outputs of the selected source as assigned to the left and right speakers.

The left connector outputs the left channel (channel A) and the right outputs the right channel (channel B). Both connectors

are configured for low impedance connections and the output signals are not affected by the volume/balance controls or

headphone mute. For XLR pinout information see the diagram below.