User guide

82 10 30: AMP x-S 8 S eries Use r Gu ide

C hap te r 5 Setup Menu

Sa vi n g a Pr es et

Naming will automatically end after you select eight characters, or

when you press the Enter button when _DONE_

_DONE__DONE_

_DONE_ appears on the

display. See Figure 5–6 above.

After naming the preset, the current state of the system is saved

under that name and preset number, and the system returns to

normal operation.

Overwriting an Existing Preset

1. Press either the Up or Down buttons to choose any preset that is

not labelled Unused

UnusedUnused

Unused.

Choosing an already used preset will display a warning to the user

that they are about to overwrite the preset, as shown in Figure 5–4

below.

Figure 5–7 Overwriting a Preset

2. Press the Enter button to display Save Old Name?

Save Old Name?Save Old Name?

Save Old Name? (Figure 5–8

on page 49) with the selected preset number and current name

below it. If you wish to use the name displayed, press Enter, and

skip the rest of the following instructions. Your current settings are

now stored in the selected preset.

Figure 5–8 Save Old Name?

Note:

The _DONE_

_DONE__DONE_

_DONE_ selection comes before the numerals, and

follows the lower case alphabet. The character order is

the order of ASCII characters.

Important:

This concludes the procedure for creating a new preset.

OVERWRITE PRESET

Preset1: Off Air

Save Old Name?

Preset3: Studio