User guide

8 21 03 0 : AM P x-S8 S er ie s U se r Gu id e

Ch apt er 5 Se tu p Men u

Sav in g a P r ese t

Creating a New Preset

1. Press either the Up or Down buttons to choose any preset labelled

Unused

UnusedUnused

Unused.

Figure 5–4 Choose an Unused Preset

2. Press the Enter button to display a prompt for a new preset name

as shown in Figure 5–5.

Figure 5–5 Assigning the Name of a Preset

3. Scroll through letters (and symbols) using the Left Up and Left

Down buttons. Press the Enter button to accept the current letter

shown in the display and move to the next letter. Repeat this

procedure until the display shows the name you want to use for

this preset.

Figure 5–6 Completed Preset Name Selection

Note:

To cancel the procedure at any time during this process,

press the Escape button and the preset will not be saved

and the unit will return to normal operation.

Choose PresetNum

Preset7: Unused

AES 1 ?@<A>BC

Name: A_

Note:

Pressing the Enter button may display multiple letters,

but the only one that changes will be the one

immediately to the left of the underscore. As a result, it

may be necessary to start the procedure over again if

too many characters appear in the display.

HD.SDI1 _DONE_

Name: HDSDI1→_