User guide

82 10 30: AMP x-S 8 S eries Use r Gu ide
© 2013 Wohl er Tec hn ologi e s , In c . Al l r ig h ts re se rved.
45
C hap te r 5 Setup Menu
Ac c es si ng S etu p M o de
1. Enable Setup mode by pressing and holding the Fn button and
then pressing the Setup button. This mode is used to change unit
features.
2. You can step through the menu selections and parameters using
the Up and Down buttons.
3. Press the Enter button to save your selections. To cancel the
option and exit the menu, press the Escape button.
The options in Setup Mode (as shown in Setup Menu Tree on page 44)
may include:
• Preset Recall (RCallPSet
RCallPSetRCallPSet
RCallPSet)
• Preset Save (SavePSet
SavePSetSavePSet
SavePSet)
• Preset Mode (PsetMode
PsetModePsetMode
PsetMode)
• Preset Erase (ErasePSet
ErasePSetErasePSet
ErasePSet)
• SDI Delay (only available for the 3G model)
• Surround Gain (Srnd Gain
Srnd GainSrnd Gain
Srnd Gain)
• Startup
• Analog Output Preference (AOutPref
AOutPrefAOutPref
AOutPref)
After entering the Setup Menu, the display will indicate the software,
version number, and the menu selection: RCallPSet
RCallPSetRCallPSet
RCallPSet (if presets are
saved).
To select the current option, press the Enter button.
Table 5–1 Up Button List
Pressing the Up
Button the...
Changes the Display to...
1st time SavePSet
SavePSetSavePSet
SavePSet
2nd time PSetMode
PSetModePSetMode
PSetMode (if presets are saved)
3rd time ErasePset
ErasePset ErasePset
ErasePset (if presets are saved)
4th time SDI Delay
SDI Delay SDI Delay
SDI Delay (3G model only)
5th time Srnd Gain
Srnd GainSrnd Gain
Srnd Gain
6th time Startup
StartupStartup
Startup
7th time A-OutPref
A-OutPrefA-OutPref
A-OutPref
8th time RCallPSet
RCallPSetRCallPSet
RCallPSet