User guide

8 21 03 0 : AM P x-S8 S er ie s U se r Gu id e

Ch apt er 3 Au di o Co nfi gu ra tio n

Mon it or ing a nd M ix in g Mod es

Single

This mode allows you to select one and only one signal for each speaker

independently of the other speaker and is most useful when you are

monitoring mono sources.

To select channels individually for each speaker:

1. Press the Fn + Single buttons to enable single channel selection.

Figure 3–5 Single Channel Selection

2. Press the Left Up or Left Down buttons to cycle through the

channel selections for the left speaker. Likewise, press the Right

Up or Right Down buttons to cycle through the channel

selections for the right speaker.

Pairs

This mode allows you to quickly assign one pair of channels to the

speakers. The selections are limited to Channels 1-2, 3-4, 5-6, and 7-8.

In all cases, the odd channel is sent to the left speaker, and the even

channel to the right. This mode is most useful when you are

monitoring stereo sources.

To select channel pairs for each speaker:

1. Press the Fn + Pair buttons to enable channel pair selection.

Figure 3–6 Channel Pair Selection

2. Use the Left Up, Left Down, Right Up or Right Down buttons

to cycle through the channel pair selections.

CH1 AES1 CH2

----

CH7 AES1 CH8

----