User guide

82 10 30: AMP x-S 8 S eries Use r Gu ide

Ch ap te r 2 System Overview

Mon ito r ing I np ut s

3. Continue on to Channel Selection and Mixing on page 22.

Monitoring an AES Input

1. To monitor an AES signal, do one or both of the following:

• Connect an unbalanced AES signal to the rear panel AES/

PCM In 1 (BNC), and/or

• Connect a balanced AES signal to the rear panel AES Bal In

& Loop Out (DB-25).

2. On the front panel, press the Input button until the LCD screen

displays the corresponding input you want to monitor:

• AES1

AES1 AES1

AES1 for an unbalanced signal (connected to BNC 1).

• AES2

AES2 AES2

AES2 for a balanced signal (connected to the DB-25).

3. Refer to Terminating/Unterminating Inputs on page 35 to check/

set your termination settings.

4. Continue on to Channel Selection and Mixing on page 22.

Monitoring an SDI Input

1. To monitor an SDI signal, do one or both of the following:

• Connect an SDI signal to the rear panel SDI In 1 (BNC), or

• Connect an SDI signal to the rear panel SDI In 2 (BNC).

2. On the front panel, press the Input button until the LCD displays

the corresponding input you want to monitor:

• SDI1

SDI1 SDI1

SDI1 for a signal to the SDI In 1 (BNC), or

• SDI2

SDI2 SDI2

SDI2 for a signal to the SDI In 2 (BNC).

Table 2–8 AES Input to Channel Relationship

AES BNC Connector Channel Outputs

1 1 and 2

2 3 and 4

3 5 and 6

4 7 and 8