User guide

8 21 03 0 : AM P x-S8 S er ie s U se r Gu id e

Ch apt er 1 In s ta l lati on

Ins t al lati o n

Electrical Interference

Be careful to apply proper input termination settings and avoid

mismatched cable types and other similar causes of undesired

reflections in digital signal systems. If severe enough, such reflections

can result in corruption of the digital data stream. As with any audio

equipment, maximum immunity from electrical interference requires

the use of shielded cable; however, satisfactory results can sometimes

be obtained without it. The internal circuitry ground is connected to the

chassis.

Power

The unit comes with a standard 24VDC/3.0 A internal power supply

and connects an A/C mains power source (65W, 100 to 240 VAC, 50/

60Hz) through the IEC connector provided on the rear panel of the unit.

When the mains plug or appliance coupler is used as the disconnect

device, the disconnect device should remain operable.

Installation

Intial Setup

1. Carefully install the monitor into a standard 19”-rack.

2. Connect all signal cables to and from associated equipment.

3. Connect the power cord from the monitor to A/C mains.

Table 1–1 Cable Length Limit Recommendations

Signal Type

Maximum Length

Meters Feet

SD 300 984

HD 150 492

3G 22 75