User manual

AMP-S8 Series+ User Manual P/N 821640 Rev-B

User Interface Function Guide

Section 2: Operation

Enabling Setup Mode: FN Button + SETUP Button

Setup Mode is enabled by pressing and holding the FN Button and then pressing the SETUP Button. This mode is used

to change unit features. Menu selections and parameters are cycled through using the the

P and D Buttons. Selections are

accepted by pressing the

ENT E Button. The currently displayed menu may be exited without saving by pressing the

ESC Button. Current settable options in Setup Mode are:

• Preset Recall (RCallPSet)

• Preset Save (SavePSet)

• Preset Create (PSetMode)

• Preset Erase (ErasePSet)

• SDI Delay

• Surround Gain (Srnd Gain)

• Startup

• Analog Output Preference (A-OutPref)

After entering Setup Mode:

The display will indicate the software, version number, and the menu selection: Setup: RCallPSet (if presets are saved).

Press theUPButton, display changes to Setup: SavePSet

Press theUPButton (again), display changes to Setup: PSetMode (if presets are saved)

Press theUPButton (again), display changes to Setup: ErasePSet (if presets are saved)

Press theUPButton (again), display changes to Setup: SDI Delay

Press theUPButton (again), display changes to Setup: Srnd Gain

Press theUPButton (again), display changes to Setup: Startup

Press theUPButton (again), display changes to Setup: A-OutPref

Press the Button (again), to cycle (return) to the first selection; Setup: RCallPSet

To select the current option, press the ENTER Button.

To exit Setup Mode, press the ESC Button.

Setup Mode

NOTE: The RCallSet, PSetMode, and ErasePSet

options will not be available if a preset has not been

previously saved to the unit. See Save Preset

(SavePSet) on page 29 for how to save a preset of the

current unit configuration.