User manual

AMP-S8 Series+ User Manual P/N 821640 Rev-B

User Interface Function Guide

Selection Modes (Cont.)

Presets:

Presets may be recalled, created, and replaced by either using the PRESETS Buttons 1-4 or by menu selection in Setup

Mode. Presets can only be erased in Setup Mode. See page 29-30 for how to recall, create, and erase presets within Setup

Mode.

Recalling a Preset: FN Button + PRESETS Button 1-4

PRESETS Buttons 1, 2, 3, 4 may be used to recall Presets 1-4 respectively, by pressing and holding the FN Button

and then pressing the corresponding PRESETS Button (1-4). This allows the user the option to recall that preset with the

following prompt.

RECALL PRESET? RECALL PRESET?

RECALL PRESET?

Preset1: Off Air Preset1: Off Air

Preset1: Off Air

Pressing the ENTER Button at this point will recall that preset.

Creating (Overwriting) a Preset:

If you do not wish to recall the preset at the prompt indicated above (Recalling a Preset), then pressing the Button

invokes a prompt to save (overwrite) the current state of the unit over that preset as follows:

OVERWRITE PRESET OVERWRITE PRESET

OVERWRITE PRESET

Preset1: Off Air Preset1: Off Air

Preset1: Off Air

Pressing the ENTER Button at this point will prompt the user whether to Keep Old Name, where the existing name can be

retained by pressing ENTER. If the user presses ES C, then they will be prompted for a new preset name as follows:

AES 1 ?@<A>BCAES 1 ?@<A>BC

AES 1 ?@<A>BC

Name: A_ Name: A_

Name: A_

If the user presses the ENT Button before finishing the naming, then the preset is not saved and the existing preset is retained. To

enter the new name, select letters using the L UP and L DOWN Buttons or R UP and R DOWN Buttons. The current

selectable character appears between the < > symbols. Press the ENTER Button to accept the current letter and move

to the next letter. Naming will automatically end after eight characters are selected, or naming can be ended by pressing the

ENTER Button when the _DONE_ selection appears. The DONE selection comes before the numerals, and follows the

lower case alphabet. The character order is the order of ASCII characters. A chart showing the character order appears in

the SAVE Preset section on page 29.

Upon completion of naming the preset, the current state of the system is saved under that name and preset number. At any

time during this process the user may press the ESC Button and the preset will not be saved and the unit will return to Normal

Operation Mode.

See page 29-30 for more information about creating, naming, recalling, and erasing presets from the menu in Setup Mode.

SDI GROUP Definition:

NOTE: The embedded channels within an SDI signal are defined and referred to in this manual as shown in the chart below:

Section 2: Operation