User manual

AMP-S8 Series+ User Manual P/N 821640 Rev-B

User Interface Function Guide

Section 2: Operation

Standard Input Source Selection: INPUT Button

In Normal Operational Mode, each press of the INPUT Button cycles through the input selections, each being visible in

the LCD Display in turn as shown:

• Analog

• AES1 (Unbalanced)

• AES2 (Balanced)

• SD-SDI1

or HD-SDI1 (Not available in DA model)

• SD-SDI2

or HD-SDI2 (Not available in DA model)

The selected input is enabled when it appears in the LCD display. In models without SDI capability, only the Analog and

AES inputs are cycled through.

Default Auto-Monitor Mode

Normal Operational Mode:

This is the default operational state of the monitor when selection modes, operational state modes, display modes, and setup

modes are not enabled. In this mode the LCD display indicates the current operational status in regard to input source and

channel selection. The Normal Operational Mode is enabled by default at unit power up.

Default Modes

(Continued)

Selection Modes

Preset Mode Selection: PRESET MODE + INPUT Button

When Preset Mode is enabled (see page 29), each press of the INPUT Button cycles through the preset names as previously

configured by the user. If an active (selected) preset is made inactive by selecting other channels or SDI groups for monitoring,

then pressing the INPUT Button will revert to the most recent preset state (as long as Preset Mode is enabled).

See Preset Mode Enable on page 29 for more information on how to select and set this parameter within the Setup Mode

menu (page 28).