User manual

AMP-S8 Series+ User Manual P/N 821640 Rev-B

User Interface Function Guide

Section 2: Operation

Default Modes:

Normal Operational Mode

Selection Modes:

Input Source Selection

Preset Mode Selection

Channel Mix Selection

Single Channel Selection

Paired Channel Selection

Downmix Selection

Recalling a Preset

SDI Group Definition

SDI Group Selection

Display Modes:

Displaying Phase/Correlation Indication

Setup Mode:

Enabling Setup Mode

Recall Preset

Save Preset

Preset Mode Enable

Erase Preset

Surround Gain

SDI Delay

Startup

Analog Output Preference

Setup Mode Menu Navigation Flow Chart

Operational State Modes:

Enabling Mute States

This Function Guide references the operation of the AMP-S8 Series+ monitors by function rather than by feature and describes

most operations in greater detail than are found in the User Interface Features section (page 18). Before using this section, it is

recommended that the Introduction to the User Interface section starting on page 16 be referred to for an understanding of the AMP-

S8 Series+ overall capabilities and an insight into how the user interface is structured and manipulated.

User Interface Function Guide

CONTENTS

Page