User manual

AMP-S8 Series+ User Manual P/N 821640 Rev-B

GROUP (SETUP) Button

Selecting SDI GROUP: > GROUP Button

When either of the the SDI inputs are selected for monitoring, the GROUP Button allows the user to select which two 4-

channel SDI audio groups are available for monitoring and presented to the left and right banks of four Level Meter

Bargraphs (Item 8, page 8).

When the buttons are pressed relatively rapidly, the order of selections are as follows: 3/4, 1/2, 1/3, 1/4, 2/3, 2/4, 3/4. But

after a selection is chosen and left until the display flashes once, slower button presses will toggle between the Group 1/2

and Group 3/4 selections. After this, rapid presses will again initiate the cycling as previously described. Since the first

two selections are more common choices, this features allows easy toggling between them. See SDI Group Definition,

SDI GROUP Selection , and SDI SUBGROUP Selection on page 26-27 for more information.

Enabling Setup Mode: > FN Button + SETUP Button

Setup Mode is enabled by pressing and holding the FN Button and then pressing the SETUP Button. See Enabling

Setup Mode (page 28) and the Setup Menu Navigation Flow Chart (Figure-2e, page 31) for more detailed information.

This mode is used to change unit features. Entries are cycled through using the or Buttons and selections are

accepted by pressing the Button. The currently displayed menu may be exited by pressing the Button.

Current settable options in Setup Mode are:

• Recall Preset (RCallPSet)

• Save Preset (SavePSet)

• Preset Mode Enable (PSetMode)

• Erase Preset (ErasePSet)

• SDI Delay

• Surround Gain (Srnd Gain)

• Startup

• Analog Output Preference (A-OutPref)

After entering Setup Mode:

The display will indicate the software, version number, and the menu selection: Setup: RCallPSet (if presets are saved).

Press the Button, display changes to Setup: SavePSet

Press the Button (again), display changes to Setup: PSetMode (if presets are saved)

Press the Button (again), display changes to Setup: ErasePSet (if presets are saved)

Press the Button (again), display changes to Setup: SDI Delay

Press the Button (again), display changes to Setup: Srnd Gain

Press the Button (again), display changes to Setup: Startup

Press the Button (again), display changes to Setup: A-OutPref

Press the Button (again), to cycle (return) to the first selection; Setup: RCallPSet

To select the current option, press the Button.

To exit Setup Mode, press the Button.

Refer to Enabling Setup Mode (page 28) and the Setup Menu Navigation Flow Chart (Figure-2e, page 31) for more

detailed information.

Section 2: Operation

User Interface Features

NOTE: The RCallSet, PSetMode, and ErasePSet

options will not be available if a preset has not been

previously saved to the unit. See Save Preset

(SavePSet) on page 29 for how to save a preset of the

current unit configuration.