User manual

16
© 2002 Wohler Technologies Inc. ALL rights reserved
AMP2-DA Instruction and Service Manual P/N 821505 Rev-B
Rear Panel Features
Section 2: Operation
(Continued)
High (+)
Low (-)
Gnd
(Shield)
Pin-1 Pin-2
Pin-3
Pin-1
Gnd
(Shield)
Pin-2
High (+)
Pin-3
Low (-)
Female XLR Pinout
Male XLR Pinout
E
F
Selected Analog Output Connectors
These two balanced (110 Ω) 3-pin male XLR connectors are analog outputs of the selected digital source as monitored by
the left (Channel A) and right (Channel B) speakers and level meters. This output is not affected by the volume/balance
controls or headphone mute. Pinout information for all XLR connectors is shown below in the diagram under Item F.
Analog Input Connectors
These two balanced (110 Ω) 3-pin female XLR connectors accept standard analog audio signals. The unit will monitor
signals input on these two connectors when the ANALOG/DIGITAL Source Select Switch on the front panel (Item 6, page
10) is set to ANALOG. Pinout information for all XLR connectors is shown in the diagram below.