Manualshelf

User guide

ManualsBrandsWohler ManualsComputer equipmentAMP2-DA
41424344454647484950
821016: AMPx-E8 Series User Guide
© 2011 Wohler Technologies, Inc. All rights reserved.
30
Chapter 3 Audio Configuration
Monitoring and Mixing Modes
Single
This mode allows you to select one and only one signal for each speaker
independently of the other speaker and is most useful when you are
monitoring mono sources.
To select channels individually for each speaker:
1. Press the Fn + Single buttons to enable single channel selection.
Figure 3–5 Single Channel Selection
2. Press the Left button to cycle through the channel selections for
the left speaker. Likewise, press the Right button to cycle through
the channel selections for the right speaker.
Pairs
This mode allows you to quickly assign one pair of channels to the
speakers. The selections are limited to Channels 1-2, 3-4, 5-6, and 7-8.
In all cases, the odd channel is sent to the left speaker, and the even
channel to the right. This mode is most useful when you are monitoring
stereo sources.
To select channel pairs for each speaker:
1. Press the
Fn + Pair buttons to enable channel pair selection.
Figure 3–6 Channel Pair Selection
2. Use the
Left Up or Right Up buttons to cycle through the channel
pair selections.