Manual


Page53

APPENDIX C: Upgrading the AMP1-16M
using Ethernet
Introduction
This chapter describes how to download software upgrades to your PC and then
transfer and install them to your AMP1-16-M.
There are two methods to update the software in the AMP1-16-M.
1. Use a USB flash drive.
2. Use the AMP1-16-M Manager to update the unit over Ethernet.
NOTE: Option 1 is only available for units with software Version 4.00 or later
installed.
Important:
If you have not yet installed the AMP1-16-M Manager setup
software into your PC you must do that first. Please see the
download and installation instructions in Appendix A before
continuing.