Manual


Page21

b. Screen Saver: Enter the amount of time you want the monitor to wait
until it invokes the screen saver. Allowable values range in 1 minute
increments from 5 minutes to 119 minutes, and in 1 hour increments
from 2 hours to 24 hours. The default setting is 8 hours. If the AMP1-
16-M is in operation for the screen saver time-out period and no front
panel controls have been turned or pressed, the screens will dim by a
certain amount. If double the screen saver time-out period elapses
without any front panel control activity, the screens will dim further.
Operating any button or control will instantly brighten the screens.
12.In the Functions Enabled area, click Trim Screen to enable the Trim
Screen and/or the Menu System to enable the menu system.
13.Audio Pair Select and Mono Channel Select: These two options control
the method of channel selection on the Main Screen of the unit.
a. Mono Channel Select – When set to Disable, both channels of a pair
are quickly selected and deselected by repeated presses of a Channel
Pair Select button. When set to Enable, multiple presses of a
Channel Pair Select button will select or deselect one or both
channels of the pair, allowing you to select individual channels. For
example, using Pair Select 3/4:
i. First press selects both channels for listening.
ii. Second press leaves only channel 3 selected.
iii. Third press leaves only channel 4 selected.
iv. Fourth press leaves both channels 3 and 4 deselected.
b. Audio Pair Select – When set to Single, only one pair may be
selected at any given time. Selecting any given pair will first deselect
any other pairs. When set to Multiple, any number of pairs may be
selected at one time for listening.