User guide

821697: AMP1-16 Series User Guide
© 2011 Wohler Technologies, Inc. All rights reserved.
76
Chapter 6 System Maintenance
Upgrading the Sub-Processor Firmware
Figure 6–10 Copy Completed
11. Once an sub-processor has been reprogrammed, wait about 15
seconds, and press
F5 to refresh the window. The window will
now appear like the one shown in Figure 6–11.
Figure 6–11 Refreshed Window
12. When all the sub-processors have been reprogrammed, cycle the
power on the unit by unplugging and re-plugging the power cord.
Important:
This concludes the upgrade procedures for both the NetBurner and the
sub-processors.