User guide

821697: AMP1-16 Series User Guide
© 2011 Wohler Technologies, Inc. All rights reserved.
73
Chapter 6 System Maintenance
Upgrading the Sub-Processor Firmware
Figure 6–6 FTP Location
8. If you see the following dialog similar to the one in Figure 6–7 after
a minute or so, it means the FTP connection failed. Try power
cycling the unit, and repeating the steps above. When you get back
to this point, press the F5 key to refresh the window.
If the unit does not respond to the FTP address you enter, you may
recheck the FTP address by rebooting the machine and returning
to the Ethernet configuration menu, or by using the IP Setup
Utility's Find button.
Figure 6–7 Failed FTP Connection