User guide

821697: AMP1-16 Series User Guide

Chapter 6 System Maintenance

Upgrading the Sub-Processor Firmware

A. From the Main Screen press the  button to launch the

menu system.

B. When the Configuration Selection Menu appears, press

the Screen Menu button.

C. When the Screen Display Menu appears, press the

Options button.

D. When the Option Configuration Menu appears, press the

HW Config button.

E. When the Hardware Configuration Menu appears, press

the Unit Info button.

2. When the

Unit Information Menu appears, press the S/W

Update

button.

3. Note the line of text at the top of the window with the FTP

address. It should read something like ftp://192.168.0.2/

Write it here ___________________________________________.

4. On the monitor, press the ENABLE FTP button.

5. Open

My Computer from the Windows desktop.

6. In the Address line, enter the address you wrote down in Step 3

(in the previous section), exactly as noted. For example, enter ftp:/

/192.168.0.2/

7. You will see something similar to the following screen shot in

Figure 6–6, if the folders are set to detail view. The filename, folder

name, and file sizes below are accurate. All other attribute

information, especially the dates, are bogus and should be

ignored.

Important:

If the address comes up as ftp://0.0.0.0/, the unit is using DHCP in a

P2P connection, or no Ethernet connection exists. See Step 1 in

Connecting to a LAN on page 90.