User guide

821697: AMP1-16 Series User Guide
© 2011 Wohler Technologies, Inc. All rights reserved.
71
Chapter 6 System Maintenance
Upgrading the Sub-Processor Firmware
Figure 6–4 Autoupdate Confirmation Dialog
6. Click
OK and both the dialog box and the AutoUpdate utility will
close, and the unit will reboot and run the new software.
Upgrading the Sub-Processor
Firmware
1. Turn the unit on and navigate to the Unit Information Menu as
shown in Figure 6–5 below.
Figure 6–5 Unit Information Menu
Note:
If the screens remain dark after updating the Netburner
firmware, the unit will enter FTP mode automatically. You
may skip Steps 1-4 below.
Serial /
Ethernet Info
S/W Update
Application: AMP1-16-3G
Unit S/W Info
Unit Information Menu
Hardware 1RU Hardware
Application Version: 01.00
Build: Sep 18 2009 08:16:42
NvRam Table Ver: 00.15
Audio FPGA Ver: 00.81
Video FPGA Ver: N/A
Graphics 0 Ver: 01.19
Graphics 1 Ver: 01.19
Graphics 2 Ver: 01.19
Front Pic Ver: 00.00
Dolby Ver: 0.0.0.0
DSP Ver: 1.22