User guide

821697: AMP1-16 Series User Guide
© 2011 Wohler Technologies, Inc. All rights reserved.
69
Chapter 6 System Maintenance
Establishing Connectivity
Establishing Connectivity
Upgrading the Netburner Software
1. Launch the NetBurner AutoUpdate utility. Click on the Find
button. You should see something similar to Figure 6–1 below.
Figure 6–1 Find Netburners Dialog
2. Click to highlight the NetBurner module you want to update, and
click
OK.
Decision Point:
If you need to establish connectivity to your PC, refer to Appendix B
on page 89.
Otherwise, continue on to Upgrading the Netburner Software
immediately below.