User guide

821697: AMP1-16 Series User Guide
© 2011 Wohler Technologies, Inc. All rights reserved.
61
Chapter 5 Menu List
Preset Management Menu
Preset Management Menu
When you enter this menu, all of the controls are set to affect the most
recently recalled preset number.
Figure 5–17 Preset Management Menu
• Copy From: Pressing this button and then rotating the Balance
knob selects the source preset for the copy.
• Save Current Config: Press this button and then rotate the balance
knob to select one of the eight presets to hold the current
configuration of the unit. Press the balance control to confirm your
selection. The label menu will then appear, where you may enter a
new name for this preset.
• Rename Preset: Pressing this button and then rotating the Balance
knob allows you to select from any of the eight presets. Pressing the
Balance knob proceeds to a text entry menu to select a new name
for the Preset.
Note:
When exiting this menu, be sure to use the  button.
Otherwise, all the changes you made in this menu will be
ignored, and all the presets will revert to their former state.
Note:
For instructions for copying the presets from one AMP1-16
Series monitor to another, refer to Copying Presets to
Another Monitor on page 32.
Preset Configuration Menu
Clear Preset
Rename Preset
Save Current Config
Copy ToCopy From
Recall on Power Up
Preset 1:
User Preset 1
Preset 1:
User Preset 1
Preset 1:
User Preset 1
Preset 4:
Preset 4:
User Preset 4
Current Configuration
User Preset 1
Note:
You should set both the Copy From and the Copy To
fields before pressing the Balance knob to execute the
copy.
Note:
This operation replaces all settings previously stored in
the selected preset.