User guide

821697: AMP1-16 Series User Guide

Chapter 5 Menu List

Monitor Mixer Configuration Menu

• Speaker Assign: This button directs audio from the channel to the

left, right, or both speakers. Pressing this button and then rotating

the Balance control knob moves the red highlight around the

speaker symbols. Pressing the Balance knob toggles the speaker

symbol active (bright green) or inactive (dark green).

• Mute Speakers: This sets whether the speakers are muted by

plugging in the headphones. Pressing this button and then pressing

or rotating the Balance control knob toggles the selection between

With Headphone or Always.

• Audio Delay: Pressing this button and then rotating the Balance

control knob changes the global audio delay. The range is 0 to 170

mS in 1 mS increments. The actual audio delay to the monitor

speakers changes dynamically as this control is turned.

• Select Source Pair: Pressing this button and then rotating the

Balance knob takes you through all the possible AES and SDI

channel pair sources.

You can choose any one of the available channel pairs of the active

SDI input card, one of the eight channel pairs of the AES input, or

Off. In a unit with Dolby enabled, the five decoded output channel

pairs are added. The choices are presented to you as SDI Pair y or

AES Pair y or Dolby Pair y.

• Phase LED On/Off: Pressing this control turns the selected phase

indicator on (bright red) or off (dark red) and enables/disables the

appearance of the phase indicator on the Main Screen.