User guide
821697: AMP1-16 Series User Guide
© 2011 Wohler Technologies, Inc. All rights reserved.
49
Chapter 5 Menu List
Hardware Configuration Menu
• Automatic: When this option is selected, the Dolby Decoder
will automatically detect and decode Dolby E or Dolby
Digital signals, and will pass PCM signals.
• Dolby E or Mute: Selecting this option mutes the Dolby
decoder outputs in the absence of a Dolby E bitstream.
• Dolby Digital or Mute: Selecting this option mutes the
Dolby decoder outputs in the absence of the Dolby Digital
bitstream.
Hardware Configuration Menu
Figure 5–9 Hardware Configuration Menu
• Screen Saver: Pressing this button and then rotating the
Balance knob
allows the user to select from any of the delay times before the screen saver
engages:
• Minutes: 5 minutes to 119 minutes
• Hours: 2 hours to 24 hours
• Analog Reference Level: Pressing this button and then rotating the
Balance knob allows the user to select from any of the following
eight analog I/O reference levels:
• -22 dBFS = +4 dBu
Note:
In this mode, if the signal is externally switched
from a PCM signal to a Dolby-encoded signal,
there will be a short burst of noise while the Dolby
card detects the new type of signal.
Hardware Configuration Menu
AES 75 ohm Term
System Reset
1 2 3 4 5 6 7 8 AES Terminate All
Unit Info
SW Upgrades
-20 dBFS = 0 dBu
Analog Reference
Level
2 hrsScreen Saver
22 22 22
Left Middle Right
Screen
Bright