User guide

821697: AMP1-16 Series User Guide

Chapter 5 Menu List

Analog Output Configuration Menu

affect each channel pair. Pressing this button highlights it.

Subsequent presses toggle between Yes and No for the selected

channel pair. The factory default is No.

• Level Trim: Pressing this control selects the left, the right, or both

level trim controls in the selected pair. Selection is indicated by the

“handle” blinking light green and dark green. Rotating the

Balance knob changes the gain. The change is indicated both

graphically and numerically.

Pressing the Balance control knob returns the trim(s) to unity gain.

This control has a range of -60 dB to +12 dB (inclusive) in 1 dB steps.

The channel can be muted by turning this control counterclockwise

beyond -60 dB.

• Analog Channel Pair: Pressing this button and then rotating the

Balance control knob takes you through each of the four channel

pairs of the analog output port. The other controls on this menu

affect the selected pair.

• Affected by Volume Control: This option is only available when

the analog output is set to monitor channels. When it is not

available, it is disabled and the options are set to No. When it is

available, it determines whether the Volume control will affect each

channel pair. Pressing this button highlights it. Subsequent presses

toggle between Yes and No for the selected channel pair.

• Channel Output: This adjustment is only available when the analog

output is not set to monitor channels since the AES outputs will

follow the channels selected in the

Monitor Menu.

Pressing this button highlights the first channel select indicator.

Subsequent presses toggle between the two indicators. Rotating the

Balance knob moves the highlight through the four indicators in

the selected channel pair. Pressing the

Balance knob toggles the

selected indicator on or off (bright green or dark green). Doing this

will assign each channel to either, both, or neither of the analog

channel outputs.

• Output Mute with Headphone: Pressing this button highlights it.

Subsequent presses toggle between

Yes and No for the analog

output.