User guide

821697: AMP1-16 Series User Guide

Chapter 4 Efficiency Enhancements

Copying Presets to Another Monitor

Backing Up the Saved Presets

1. Create a folder on your PC’s desktop called Presets.

2. Follow the instructions in Appendix B on page 89 to establish

connectivity to the AMP1-16 Series monitor.

3. Follow the instructions in Appendix C on page 97 to set up the

AMP1-16 Series monitor for an FTP file transfer.

4. Press the F5 key to refresh the window.

5. Drag and drop the Presets.S19 file from the AMP1-16 Series

monitor to the Presets folder on the desktop.

6. We recommend that you rename the file so you can distinguish

multiple presets files. You must, however, maintain two parts of

the filename (both of which are case-sensitive):

• The word Presets (plural) must appear in the filename.

• The file’s extension must be .S19.

7. Once the file is copied, disconnect the AMP1-16 Series monitor

from the PC.

Copying the Presets to Another Monitor

1. Connect the destination AMP1-16 Series monitor to your PC.

Note:

These instructions assume that neither of the AMP1-16

Series monitors have been configured to connect to your PC.

If they have already been configured, skip only Step 2.

Important:

If the new filename does not meet the requirements listed in Step 6

above, the AMP1-16-3G Series monitor will not accept the file.

Examples: Acceptable filenames:

• My Presets.S19

• 090909 Presets.S19

Unacceptable filenames:

• My Preset Set.S19

• My presets.s19

Important:

This concludes this half of the preset copying procedure. Continue on

to Copying the Presets to Another Monitor immediately below.