User guide

821697: AMP1-16 Series User Guide

Chapter 4 Efficiency Enhancements

Copying Presets to Another Monitor

Figure 4–1 Unit Information Menu

2. When the

Unit Information Menu appears, make a note of the

following:

NvRam Table Version: ________________________________________

Dolby Version: _______________________________________

3. Power up the second AMP1-16 Series monitor and repeat the

previous Steps (1 through 2) above.

Decision Point:

If the NvRAM versions are the same for both units, then they are

compatible. (It is also acceptable for the source unit to display “N/A”

and the target unit to have a version number.) Continue on to Backing

Up the Saved Presets immediately below.

Otherwise, if one or more of the lines in Step 2 is not the same, then

this procedure will not work. You can do one of two things:

• Manually configure the second AMP1-16 Series monitor, or

• If the units have the same hardware and software versions, then

you can upgrade the software on one, or both units so that the

NvRam Table Versions match. Then after reconfiguring the first

one manually, you can use this procedure to copy its preset file to

the second one.

Serial /

Ethernet Info

S/W Update

Application: AMP1-16-3G

Unit S/W Info

Unit Information Menu

Hardware 1RU Hardware

Application Version: 03.00

NvRam Table Ver: 00.20

Audio FPGA Ver: 01.00

Video FPGA Ver: N/A

Graphics 0 Ver: 02.00

Graphics 1 Ver: 02.00

Graphics 2 Ver: 02.00

Front Pic Ver: 00.00

Dolby Ver: 2.1.2.6

DSP Ver: 1.30