User guide

821697: AMP1-16 Series User Guide

Chapter 4 Efficiency Enhancements

Presets

Clearing a Preset

1. From the Configuration Selection Menu, press the Preset

Management

key to display the Preset Configuration Menu.

2. Press the Clear Preset button.

3. Rotate the Balance knob to highlight the preset you want to clear.

4. Press the

Balance knob to select the preset.

2. Press the Select button to initiate the Balance knob for character

selection.

3. Rotate the Balance knob until the M is highlighted.

4. Press the Balance knob to select the character.

5. Press the

Shift button to display the lower case character set.

6. Note that you do not need to press the

Select button a second

time; simply rotate the

Balance knob until the y is highlighted.

7. Press the

Balance button to select it.

Repeat this process for each character of the label. Note that the

space bar character is immediately to the right of the 9. To correct

mistakes, press the Backspace button.

8. To save the new label and return to the Preset Configuration

, press the  button.

9. To verify your changes, look at the text to the right of the

Rename Preset button. Your preset should still be in the display

area with its new name.

Important:

The monitor will display a warning message to let you know that you

are about to clear the preset. You must respond by pressing the Clear

Preset

button again before the warning disappears (approximately

five seconds) or you must start over by pressing the Clear Preset

button again.